A leaking shed roof can ruin tools, bikes and anything else stored inside, and the damage spreads fast once the boards get wet. Knowing how to fix shed roof leaks early saves a lot of money. In most cases the job is either a simple felt patch or a full re-felt, and both are well within reach for a careful DIYer.
This guide explains what a shed roof is, the faults that affect it most, the tools you need and each repair step in plain English. If water is already coming through a ceiling, read our guide on how to fix a leaking roof from the inside first, then come back here for the outside repair.
What is a shed roof?
A shed roof is a single flat plane that slopes in one direction, also called a mono-pitch roof. The term is also used for roofs on garden sheds, which are usually covered in bitumen felt over timber boards.
Why is my shed roof leaking?
| Cause | What you will see |
|---|---|
| Torn or cracked felt | Splits, bald patches, felt lifting at the edges |
| Rotten roof boards | Soft spots, sagging between rafters |
| Poor overlaps | Water running in along felt joints |
| Rusted or missing nails | Felt flapping in the wind |
| No drip edge | Water running back under the edge and rotting the frame |

How do you patch a shed roof?
- Brush the area clean and let it dry.
- Cut a felt patch at least 75 mm bigger than the tear on each side.
- Spread felt adhesive under the patch area.
- Press the patch down and nail around the edge with clout nails about 50 mm apart.
- Seal the patch edges with a little more adhesive.
How do you re-felt a shed roof step by step?
- Strip off the old felt and pull out every old nail.
- Replace any soft or rotten OSB or tongue-and-groove boards.
- Start at the lowest edge. Lay the first strip so it overhangs the edge by about 50 mm.
- Nail along the top edge, then fold and nail the overhang under the edge to form a drip.
- Lay the next strip so it overlaps the first by at least 75 mm, sealing the overlap with adhesive.
- Finish at the top (or apex) with a capping strip that laps over both sides.
- Fold and fix the felt at the gable ends, then fit fascia boards to protect the edges.
Should you use felt, shingles or EPDM on a shed?
Standard shed felt is cheapest. Felt shingles look neater and last longer (see what roof shingles are). EPDM rubber gives the longest life and suits low-slope sheds, but costs more and must be fully bonded.
How do you make a shed roof last longer?
- Keep overhanging branches cut back.
- Clear leaves so water runs off freely.
- Fit a gutter so water does not splash the walls.
- Check the felt each autumn and re-nail any lifted edges.
Is it safe to stand on a shed roof?
Most shed roofs are not built to take a person’s weight. Work from a stepladder or platform beside the shed, and never kneel on thin boards. For larger outbuildings or garage roofs, a roofer may be the safer choice.
Conclusion: How to Fix Shed Roof Leaks the Right Way
To fix a shed roof, check whether the problem is the covering or the boards underneath. Small tears in the felt can be patched. If the felt is cracked all over or the boards are soft, strip it back, replace any rotten boards and lay new shed felt with overlapping joints and a proper drip edge.
Key points to remember:
- Most garden sheds have a single slope or a shallow apex covered in felt.
- Soft, spongy boards mean water has been getting in for a while.
- Felt should overlap by at least 75 mm and finish over the edges with a drip.
- Shed felt lasts longer when it is nailed with clout nails and battens are not over-tightened.
Now you know how to fix shed roof leaks in the right order. Work in dry, calm weather, follow the HSE’s advice on working at height, and stop if the timbers feel soft or the job is out of safe reach. For what to do while water is still coming in, see our main guide on how to fix a leaking roof from the inside.
Previous guide: How to fix a gambrel roof · Next guide: How to fix a butterfly roof
Shed roof repair FAQs
How long does shed felt last?
Basic shed felt often lasts 5 to 10 years. Better-quality felt and shingles last longer.
Can I put new felt over old felt?
It is better to remove old felt so you can check the boards. Laying over damp felt traps moisture.
What nails should I use for shed felt?
Use galvanised clout nails with large flat heads, which hold the felt without tearing it.
More Roof Repair Guides by Roof Type
- How to fix a gable roof: verges, ridge and bargeboards
- How to fix a hip roof: hip tiles, hip irons and cut tiles
- How to fix a flat roof: felt, EPDM and GRP patches
- How to fix a mansard roof: the kerb, slates and dormers
- How to fix a gambrel roof: the break line and sagging
- How to fix a butterfly roof: the central valley gutter
- How to fix a Dutch gable roof: the gablet, verge and hips
- How to fix a pyramid roof: the apex, finial and hips
- How to fix a skillion roof: abutment flashing and pitch
- How to fix a dormer roof: lead soakers, apron and window seals
- How to fix a saltbox roof: the long slope, gutter and ridge
- How to fix a bonnet roof: the change of pitch and sprockets
- How to fix an M-shaped roof: the central valley and twin ridges
- How to fix a clerestory roof: window seals and abutments
Phillip Holland is the founder of Experienced Roofers Ltd, bringing 30 years of roofing and construction expertise to homeowners across Wiltshire. A certified roofer who has overseen hundreds of projects, Phillip writes to demystify roofing problems, covering everything from spotting early leak damage to choosing the right roofing material and knowing when it’s time to call a professional.